Kitset Park Benches

Our kitset Park Benches can be built by just about anyone using a battery drill or impact driver, and their sturdy design will give years of reliable service.

Available in two-person and three-person designs, these make a great addition to your outdoor area.

All timber is cut to length and ready for assembly with the included hardware - you just need to put it together!

	Length (total)	Length (seat)	Height	Depth	Price (inc. GST)
2 seater	1400mm	1200mm	850mm	700mm	$400
3 seater	1800mm	1600mm	850mm	700mm	$450

Click here to contact us now to make an enquiry or place an order.

All necessary screws are included in the kitset. Outdoor furniture oil is an optional extra.

You will need a hammer, 16mm spanner or socket, impact driver or battery drill, sandpaper to smooth off any sharp edges.
An outdoor timber oil should also be applied to ensure longevity - we recommend and sell CD-50 outdoor timber oil.

Assembly Instructions

1) The Long and Short legs will come pre-bolted together - orient these so you have the Short leg in the inside of the bench on both sides.

---

2) Stand the legs upright and get an assistant to hold them in position while you place the Seat on the top of the Short Legs. Make sure the bottom front edge of the Seat aligns with the edge of the Long Leg, then screw it in place using six 75mm Bugle Screws.

---

3) Fix the back rest to the back of the Long Legs using six 75mm Bugle Screws, making sure it is flush with the top of the Back Legs.

---

4) Fix an Arm to the front of a Long Leg at the point where there is a change of angle on the Long Leg. Use two 100mm Bugle Screws to go through the Arm and into the Long Leg. Then, use one 75mm Bugle Screw in from the Long Leg side into the Arm.

---

5) Repeat step 4 for the other Arm.

---

6) Using coarse sandpaper take any sharp edges off the timber. Alternatively use a router with a rounding bit.

---

Sealing the bench seat: To finish your bench seat, seal the timber with CD-50 to protect it from the elements.